Publicité
J
K
4
L
M
2
N
All manuals and user guides at all-guides.com
3
2
1
3
1
ENGLISH
INSERTING A CASSETTE → J
Insert a cassette with the recording/playback side (a) facing the cassette holder.
RECORDING FROM THE BUILT-IN
MICROPHONE → K
1 Insert a cassette.
2 Set the REC MODE switch.
NORMAL: Normal recording
3 ×
: Triple time recording (with third speed)
E.g.) An 180-minute recording can be made using both sides of a
C-60 cassette tape.
3 Orient the built-in microphone to the sound source.
4 Press the wREC button to start recording.
The jPLAY button is depressed simultaneously and the REC indicator
lights. The indicator lights and goes out according to the voice input.
Basic operation
To stop recording
Press the sSTOP button.
To pause recording
Set the PAUSE switch in the direction of the
arrow (U). The REC indicator lights.
To resume recording, set the switch in the
opposite direction.
• The PAUSE switch is released automatically when the sSTOP button is pressed.
When the end of the tape is reached during recording
The tape stops automatically.
When using the unit on the desk → L
Place it as illustrated during recording to reduce the noise.
To select the sensitivity of the microphone
Set the MIC SENS switch according to the location of recording.
HIGH: When recording in a conference etc.
LOW: When recording a dialogue nearby
Note on setting the REC MODE switch
A tape recorded with the REC MODE switch set to 3 × can be played back by only
the tape recorders having the same function with this unit.
If you are going to play back the tape by other than this unit, be sure to set the
REC MODE switch to NORMAL before recording.
Tape counter → a
The readout of the tape counter changes during playback, recording, fast-
forwarding or rewinding of the tape.
To set the counter to 000, press the counter reset button b to the right of the
tape counter.
To record only the sound louder than the preset sound
level → M
Recording will start when the unit detects sound above a certain preset level. If
the unit does not detect the sound for about 4 seconds, recording will pause.
This prevents tape waste and empty recording.
1 Set the V-SENSOR switch to ON.
2 Adjust the sensor level.
Turn the VOL/V-SENSOR LEVEL control in the direction of a to increase the
sensor level. Even relatively quiet sounds will be recorded.
Turn the VOL/V-SENSOR LEVEL control in the direction of b to lower the
sensor level. General background noise will not be recorded, and only relatively
loud sounds will be recorded.
3 Press the wREC button to start recording.
Sensor level adjustment
The ideal sensor level varies according to the loudness of the source sound.
Experiment with the sensor level in advance to determine the optimum level before
you start an important recording. Usually set the VOL/V-SENSOR LEVEL control
to 4 to 6 first, then adjust it according to surrounding conditions.
Note
When the recording resumes after sound detection, the very first sounds may not
be recorded.
To record the human voice more clearly → N
When the voice you want to record is soft, and the surroundings are noisy, set the
NFR switch to ON and start recording. The voice will be recorded more clearly.
How NFR (Noise Filtration Recording) works
NFR emphasizes the frequency range of the human voice more than the high
and low frequencies that usually comprise noise.
O
Publicité
