Regulation (Digital Controller) - Cillit PoolPAC 6 Manuel D'instructions

Regulation (digital controller)

ON/OFF
When you switch OFF the machine on the controller, the display will indicate « Stand-by »
Button serves to start/stop the heat pump.
After stopping the machine with this button, it can take a few minutes till the machine comes to a complete hold.
Working modes
Button serves to change the working mode.
By pressing this button, the icon corresponding to the selected mode will appear:
•
•
•
Time setting
•
Keep key pressed for 3 seconds (hours will blink)
•
Set hours with
•
Press one time button
•
Set minutes with
•
Press one time button
Water temperature setting
Start the machine and choose the desired mode (see precedent instructions).
Normal display in heating mode
Automatic: heating and cooling.
The heat pump will maintain the water temperature at the desired value (+/– 1°C)*.
Heating: only heating.
Heats the water up to the desired value (+/– 1°C)*.
Cooling mode: only cooling.
Cools the water down to the desired value (+/– 1°C)*.
or .
(minutes will blink)
or .
to confirm.
Buttons below the display
- 24 -
All icons available