Electrical Connections - Cillit PoolPAC 6 Manuel D'instructions

If your installation is equipped with water treatment devices (chlorine, brome feeder, salt water chlorine generator,
others) the by-pass must be installed before the water treatment devices, with a non-return check valve between the
by-pass and water treatment devices.
Water inlet and outlet are designed to be connected to rigid pressure PVC tube (for swimming pool) Ø50 mm, directly
glued to the half union connectors provided.
Inlet water tube must be connected to connection labeled:
Outlet water tube must be connected to connection labeled:
Water tubes must be fixed on the floor or the walls, so the heat pump will not support the weight of the water inside the
plumbing.
Do not use a clamp or other tool to screw the connections, hand screwing is sufficient.

Electrical connections

Electric supply voltage and current values must correspond to the ones indicated on the heat pump.
Connection cables must to be sized according to the appliance power and installation requirements.
Model
Cillit PoolPAC 6
Cillit PoolPAC 9
Cillit PoolPAC 11
Cillit PoolPAC 14
Cillit PoolPAC 16
It is recommended to use wire terminal for better electrical contact between wire and power supply terminal.
These data are only indicative, you must ask an electrician to determine the exact data for your pool
installation.
Power supply must be equipped with grounding and 30 mA differential protection.
A wall mounting box, specially build for each model is available as an option. It contains head of line D-curve protection
and differential.
Head of line
Power
protection
supply
(D curve)
3G 230 V
3G 230 V
3G 230 V
3G 230 V
3G 230 V
*Total cable length between heat pump and main power supply of the house
Maximum cable length* with diameter:
2,5 mm²
10 A 35 m
16 A 20 m
20 A 10 m
20 A 10 m
-
25 A
- 21 -
4 mm² 6 mm²
50 m 70 m
30 m 40 m
20 m 30 m
20 m 30 m
20 m 30 m
10 mm²
100 m
70 m
50 m
50 m
50 m