Power Fist 8001260 Manuel Du Propriétaire page 3

All manuals and user guides at all-guides.com
Forward/Reverse Switch
Adjusting the direction of rotation:
1. Counter clockwise: push the switch to the right.
2. Clockwise, push the switch to the left
To remove the keyless chuck
The chuck is locked in position with the
locking screw (A) Open the bit holder
completely and fully unscrew the locking
screw. The locking screw has a left hand
thread.
Torque control
The drill driver is equipped with an adjustable clutch that is
controlled by the torque adjusting knob. When properly adjusted, the
clutch will slip at the present torque to prevent driving the screw too
deep and to prevent damage to the tool.
Correct setting of the knob depends on the
type and size of the screw and the material
used in a specific application. Always start at
the lowest clutch setting and increase the
setting until the desired results are obtained.
Charging the battery
The battery (B) does not come charged from the factory. Charge
before use.
1. Plug the transformer (A) into a wall outlet.
2. Insert the battery (B) into the transformer (A). The battery can only
be inserted one way.
3. Push the set button (D). The red charging light (C) will come on.
At the end of the 1 hour charging cycle, the green full charge light
(E) will come on and the charger will shut off.
4. After charging, unplug the transformer adapter from wall outlet.
5. Insert the battery (B) into the tool