Set the temperature control
knob to the desired tempera-
ture.
Set the cursor to position
NB : When there are no instructions from the pilot wire, the appliance heats in Comfort mode
tions for Frost
and Stop
time is around 12 seconds when switching from Comfort mode
HOW TO USE THE ENERGY-SAVING FUNCTIONS
To use these functions, we recommend that you set the cursor to Comfort
mode.
PROG
These functions are in addition to the programming functions.
ACTIVATING THE AIRING DETECTION FUNCTION
Do not heats the room while it is being ventilated allow you to save energy. If you do not turn off your
heater when a window is open for a long time, the airing function
when it is not necessary: your heater automatically detects when the window is opened or closed and
therefore saves energy.
Your device reacts to an open or close window according to several variables, especially
- the temperature settings programmed for the room
- the outside temperature
- the location of your heater, etc.
By detecting whether the window is open or closed, the
airing function helps you to be environmentally friendly:
you save energy by not heating your house when you
ventilated it.
NB: If the function does not meet your requirements, you can manually stop the device from heating (Stand-by
mode
). When the function is running, the green LED flashes slowly.
ACTIVATING THE ABSENCE DETECTION FUNCTION
The absence detection function
automatically, as soon as you leave it.
The programming instructions (
.
PROG
take priority over Eco mode
enables you to lower the temperature setting for your room
) take priority over absence detection.
PROG
The heating light illuminates if
the room's ambient temperature
is below the desired tempera-
ture for the selected mode
(Comfort temperature in Comfort
mode
ture in Eco mode
PROG
and Comfort mode
to Eco mode
stops your device from heating
Optimum zone
29
and reduced tempera-
).
. The instruc-
. The changeover
.
or Programming
GB