Troubleshooting - Reer Apollo Notice D'utilisation

11. Intercom function
The parent unit provides you with the opportunity of calming your child with consoling
words, when your child is active. To do so, press down on the intercom button (1) – fi g.15 –
and speak in the direction of the microphone (10). During this process, the colour display
(4) goes into the transmission mode and you receive an image of the baby. If you let go of
the intercom button (1) on the nursery unit, the transmission to the nursery unit is discon-
nected and the parent unit goes back to the mode set.

Troubleshooting

problem
No reception with the
parent unit
Rechargeable batteries
cannot be charged
Nursery unit camera is not
transmitting
Cleaning and maintenance:
Never submerge the devices in water and never clean them under running water. Remove the power supply
units from the power outlet and clean the devices with a damp cloth. Before using the devices again, please
make sure that they are completely dry before connecting them to the power supply system.
All technical specifi cations, information as well as features of the product described in these works were
compiled to the best of knowledge and according to the status at the time of publication. The informa-
tion provided by reer is intended to be correct and reliable. However, reer does not assume any liability
for possible errors in this document and reserves the right to modify the product design or specifi cations
without prior notice.
Duplications or the transmission of information from these copyrighted works in any form, graphically, elec-
tronically or mechanically, by means of photocopying, recording on tape or saving in a retrieval system
– even in extracts – require prior written approval from reer.
All manuals and user guides at all-guides.com
possible source of error
- The camera on the nursery
unit is not transmitting, power
supply unit is not connected
or the camera is in Vox mode
- The On/Off switch on the
nursery unit is in the Audio
position
- Discharge the rechargeable
batteries for the parent unit
- Adapter is not connected
properly
- Using alkaline batteries
- Nursery unit is switched off
- Adapter is not connected
- Nursery unit is in Vox mode and
baby' s noise generation below
50 dB
- Parent unit is in Audio mode
15
What to do?
- Connect power supply unit to
nursery unit
- Move On/Off switch from Vox
mode to "OFF" position
- Move On/Off switch on
nursery unit to "ON" position
- Check whether the LED control
lamp on the parent unit is
red, connect power supply
unit and charge rechargeable
batteries
- Check whether the LED control
lamp is red, connect power
supply unit
- Remove alkaline batteries and
insert rechargeable batteries
- Switch the On/Off switch to
the "ON" position
- Connect the adapter
- Change the sensitivity setting
of the Vox function to the next
level
- Adjust the On/Off switch to
the "ON" position
- 17 -
ATTENTION!
Under no circumstances should
you attempt to repair the devices
on your own.
NOTE:
If the nursery or parent unit is not
functioning properly or unexpected
errors occur, we kindly ask you to:
1) fi rst carefully read the respective
section in the instructions for
use again.
2) then, please try to fi nd and
rectify the error with the help of
the troubleshooting chart
3) if the error cannot be rectifi ed,
we kindly ask you to contact
your specialist dealer