Clarion VT800B Manuel D'utilisation page 29

All manuals and user guides at all-guides.com
3. Route the cables through the hole to the location of any audio/video sources.
4. Identify the dome light wires in the vehicle and connect them to the corresponding
dome light wire on the overhead monitor system.
5. Plug in any audio/video source cables.
6. Plug in the power harness into the overhead monitor system in the following order:
ground wire, battery wire, ACC wire and door wire.
Note:
Do not forget to connect the red ACC wire to the ignition switch.
If you do not connect this wire, the battery charge may drain off
prematurely.
Install the monitor
1. Carefully hold the overhead monitor up to the metal mounting plate.
2. Screw in the four CM 4 x 8 screws making sure the wires are not in the way.
3. Reconnect the battery.
4. Check the car's brake lights, blinkers, wiper, etc. to ensure they are working properly.
VT800B/VT1000B/VT1000T/VT1500B
Mounting the player
2 9