Waterpik waterflosser Guide De Démarrage Rapide

QUICK START GUIDE
1
FIRST USE
Fill reservoir with
warm water and
replace it firmly
on the base.
3
LEAN OVER SINK
Close lips enough to
prevent splashing, while
still allowing water
to flow from mouth
into the sink.
Model WP-950/952
This device is compatible with voltages of 120 VAC, 60Hz.
Turn pressure to high,
point tip into sink, turn
power and water switches
on until water flows.
Insert
Insert tip firmly until
it clicks into place.
4
Aim water just above the
gumline at a 90 degree angle.
Follow the gumline and pause
briefly between teeth.
Review full instruction book prior to first use
Power
ON
High
Water ON
TECHNIQUE
2
START WATER FLOSSING
Turn power and water on.
Start on low pressure and
increase to your liking.
TO AVOID MESS:
PLACE THE TIP
IN YOUR MOUTH
BEFORE TURNING
UNIT ON
5
HOW TO VIDEO
Visit
waterpik.com/VID950
Register your product and
receive over $30 in savings.
waterpik.com/registration
© 2017 Water Pik, Inc.
1.800.525.2774 (USA) 1.888.226.3042 (Canada)
English