RCA RPW210 Manuel D'instructions page 11

How To Use
Washing a load of laundry
Step 3: Add detergent
This washer is designed for high efficiency (HE) powder detergent
only. Draw the compartment out and add the recommended
amount of detergent directly into the detergent compartment
before starting your washer. The normal amount of detergent
to use is 1/4 to 1/2 of the maximum amount recommended by
the detergent manufacturer. Always reduce the a m o u n t o f
detergent if the load is small or lightly soiled, or if your water
i s v e r y s o f t . N e v e r u s e m o r e t h a n t h e m a x i m u m a m o u n t
recommended by the detergent manufacturer.
Never pour any liquid bleach directly onto the load. It can cause fabric
damage, such as weakening of cloth fibers or color loss.
WARNING
Step 4: Select your desired cycle and options
First, select your desired washing program.
Heavy (light)
Jeans (light)
Normal (light)
The Air Dry cycle can help remove some moisture from clothing
to reduce drying time and cost.
Large Second, select the water level based on a High, Medium or Low
load size. Press the Load Size button to change the water level
Medium
setting.
Small
Load Size
Third, select your desired wash cycle steps. If you want the
wash cycle to perform all three steps, just keep them lighted.
Pressing the button will change the number of steps performed.
In addition to Wash /Rinse /Spin you can select Wash /Rinse ,
Rinse /Spin , Wash , or Spin .
Fourth, select your desired water temperature for washing action.
For some cycles, options in this function will be limited accordingly.
Cold light only indicates Cold Water selection
Both Cold and Hot light together indicate Warm Water selection
Hot light only indicates Hot Water selection
Note: The temperature setting is just for washing action.
Rinsing action is cold water only for all cycles.
Quick (Flash)
Anti-wrinkle (Flash)
Air dry (Flash)
19
How To Use
Washing a load of laundry
Remain(min) Last, you may delay the start time for washing if desired.
Press the Delay button. The display will change from
minutes to hours. Each further press of the Delay button
will add 1 hour to the display up to 24 hours.
Delay(Hr.) Now each further press will add 6 hours to the display
up to 48 hours. One more press will cancel the Delay
function and the display light will turn off.
Step 5: Start the cycle
Press the START/PAUSE button to start the washing cycle.
When the washing cycle begins, the Estimated Time in
minutes for the cycle to complete will show and count
down in the digital display. Or, if Delay Start is set, the
display will count down the hours until the cycle begins,
and then change to a minute countdown for the cycle.
When the washer is running, you should pause the program and wait for the
basket stopped completely before you open the door.
WARNING
Note:
If you want to cancel the Delay Start function after it is started, you should power
off the unit and reset all functions before restart the unit.
Control lock
This function is useful to prevent children from changing the operation
status of the unit.
WARNING
Press and hold the "Function" and "Load Size" buttons
simultaneously to activate this function.
The digital display will show "CL". The"CL" and remaining
Load Size
time or Delay Start time will be displayed in turn .
Remain(min) Press and hold the "
simultaneously again to deactivate this
T h e " CL " display w i l l d i s a p p e a r w i t h o n l y
time or Delay Start time displayed.
When Control Lock is activated, no buttons will function
except for POWER and the ability to deactivate Control
Lock as described above.
Function " and " Load Size " buttons
function.
remaining
20