Maytronics AstralPool Pulit E70 Guide D'utilisation page 6

English
Turning the Pulit E70 on
1. Plug the floating cable from the Pulit E70
into the power supply unit.
2. Plug the electrical cable from the power
supply unit into the mains.
3. Press the ON/OFF switch
4. The Pulit E70 will now start to work.
Note : If your model includes the remote control unit, please refer to the included instruction leaflet.
Part 3 - Taking the Pulit E70 out of the water
Unplug power supply before any servicing activity.
1. If the Pulit E70 has not finished its cycle, turn off the power supply
unit and unplug the mains.
2. Pull the floating cable gently until the Pulit E70 has risen to the
surface, then lift by the handle.
Important: Do NOT lift the Dolphin from the water by its cable.
Floating cable
On/Off
switch
6