Power Supply Unit - Maytronics AstralPool Pulit E70 Guide D'utilisation

English

3. Power supply unit

Digital, "Switch-Mode" power supply:
Input - 100-250 AC Volts
50-60 Hertz
180 Watt
Output - 30 VDC
IP 54
Section 2 – Pulit E70 Operation
Part 1 – Preparing the Pulit E70 Pool Cleaner for Use
A. Assemble the Caddy kit – you will find the instructions in a separate document
B. Adjusting the handle float angle
The handle angel must be adjusted to determine the speed that the Pulit E70 advances along the water-line.
1. Lay the handle down at an angle of 180º to
the ground.
2. Push the base of the arm into the body of the
Pulit E70 and slide it towards the rear of the
Pulit E70 until it clicks into the required position.
Normal advance
More efficient cleaning action on water-line.
Fast advance
Fast speed – For faster but less efficient cleaning
action on water-line.
Push in here
Push in here
Slide here
On/Off
switch
Slide here
4