Breville the Tea Maker BTM800XL Manuel D'instructions page 31

TROUBLESHOOTING
PROBLEM
Tea Maker will not
switch 'ON'
The Tea Maker will
not work
The LCd light has
gone out
I cannot select a
certain function
The LCd screen
displays 'RESET'
The LCd screen
displays 'ERROR'
BTM800XL_IB_H13.indd 31
EASy SOLUTION
• Check that the power plug is securely inserted into the outlet
• Insert the power plug into an independent outlet
• Insert the power plug into a different outlet
• Reset the circuit breaker if necessary
• For additional safety the Tea Maker is fitted with a thermal
cut out. In the event of severe overheating, the Tea Maker will
automatically shut down to prevent further damage. Should
this occur, call Breville Consumer Support.
• Check that the Glass Jug is securely positioned on the
Power Base.
• The Tea Maker goes into standby mode if not used for
3 minutes. When in standby mode, the LCD screen will
cease to illuminate.
• To re-activate the Tea Maker out of standby mode:
− Remove then replace the Glass Jug from the Power Base.
− Press any button on the Power Base except the HOT
WATER|Cancel or TEA|Cancel buttons. The LCD screen
will re-illuminate.
• Certain features cannot be selected or changed during the
heating or brewing cycle. The LCD screen may temporarily
change or a sound alert may be heard, but no changes to the
cycle will be made.
• The LCD screen will display a flashing 'RESET' when there is
a resettable electronic issue. Lift the Glass Jug off the Power
Base then put it back on. Alternatively, remove the plug from
the wall outlet, wait 5 seconds, then plug back in.
• Call Breville Consumer Support if the 'RESET' message
continues.
• The LCD screen will display a flashing 'ERROR' when there is
a non-resettable issue with the appliance. Should this occur,
call Breville Consumer Support.
31
17/09/13 4:48 PM