Installing The Light Bulbs & Glass Shade; Fan Without Light Fixture (Optional) - Kichler 52" Terra Select Manuel D'instructions

INSTALLING THE LIGHT BULBS & GLASS SHADE
Step 1. Install each of the 4 watt LED bulbs (included). One in each socket.
Step 2. Remove the decorative nut, glass cap and metal nut from the light kit. Place
glass shade over the light kit stem, secure with the metal nut (rubber side on the top),
glass cap and decorative nut. Do not overtighten. (Fig. 18)
Step 3. Restore power and your light kit is ready for operation.

FAN WITHOUT LIGHT FIXTURE (OPTIONAL)

NOTE: Before starting installation, disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box
Step 1. Raise the switch housing close to the ceiling fan and connect the square
wire connectors from the switch housing and fan. Install the switch housing to the
mounting plate with screws provided. (Fig. 19)
Step 2. Attach the plastic plug to the switch housing. (Fig. 19)
Bulbs
Glass shade
Metal nut
Glass cap
Decorative nut
Fig. 18
Connection plug
Mounting plate
Switch housing
Screws
Plastic plug
Fig. 19
52" Terra Select |
15