GUARDO Action Cam 4 Mode D'emploi page 11

WATERDROPS & CONDENSATION
Regulary check the lens to see if waterdrops or condensation/fog have appeared as these
may be shown on your footage.
To remove/avoid waterdrops and condensation/fog, these tips might help :
• Spit or lick the port or housing lens. The water will sheet off instead of beading up!
• Apply a water repellent and anti-beading/ anti-fog coating or wax (such as 'RAIN-X)
• Make sure the inside of the housing and camera is as dry as possible (e.g. dry hands, no
sweat) to prevent fog/condensation
• Don't leave the camera in the direct sun or near heat and don't leave it ON (generating
heat) when not necessary
• Open the fogged camera housing and carefully wipe off the fog inside, then close it again
• Try to avoid too large temperature differences as these may cause condensation/fog
Anti-Fog inserts are optionally available on www.guardo.be.
Note: 'Muffled' sound is inevitable when using the camera with the waterproof housing.
MOUNTING THE CAMERA USING THE
Attaching the camera to any mount, is always done in the same way:
1. Remove the screw from the mount.
2. Place the camera on the mount with the screw.
3. Rotate/Tilt the camera into the desired shooting angle and fasten with the tightening screw.
DELIVERED MOUNTS
11