Cool Mode; Heat Mode - Qlima P522 Manuel D'utilisation

4
76
man_P(H)5xx('17).indd 76
to make the appliance turn on. The last function active when it was turned
off will appear.
G
Never turn the appliance off by unplugging from the mains. Always press
the button , then wait for a few minutes before unplugging. This
allows the appliance to perform a cycle of checks to verify operation.
DESCRIPTION OF THE DISPLAY SCREEN
Plug into the mains socket, then the appliance is standby. Press the
to make the appliance turn on. The last function active when it was turned
off will appear.

COOL MODE

Ideal for hot muggy weather when you need to cooling and dehumidify the
room.
To set this mode correctly:
• Press the M button a number of times until the
• Select the target temperature18°C-32°C(64 °F-90°F) by pressing the /\ or
v button until the corresponding value is displayed.
• Select the required fan speed by pressing the
Three speeds are available:
Maximum speed: for maximum fan power
Medium speed: reduces noise levels but still maintains a good level of comfort
Low speed: for silent operation
The most suitable temperature for the room during the summer varies from 24°C
to 27°C(75°F to 81°F ). You are recommended, however, not to set a temperature
much below the outdoor temperature. The fan speed difference is more
noticeable when the appliance is under FAN mode but may not be noticeable
under COOL mode.

HEAT MODE

* means only the heat pump model have this function.
To set this mode correctly:
• Press the M button a number of times until the
• Select the target temperature 13"C-27°C(55 °F-81°F) by pressing the /\ orV
button until the corresponding value is displayed.
• Select the required fan speed by pressing the
Three speeds are available:
Maximum speed: for maximum fan power
Medium speed: reduces noise levels but still maintains a good level of comfort
Low speed: for silent operation
• Water is removed from the air and collected in the tank.
• When the tank is full, the appliance shuts down and "
on the display. The tank cap must be extracted and emptied. Run off all
button
symbol appears.
button.
symbol appears.
button.
" (full tank) appears
27-12-17 12:31