NEC PlasmaSync 42XM4 PX-42XM4A Manuel D'utilisation page 44

Dots lines
Model
Signal Type
Work Station 1024 768
(SGI) 1280 1024
IDC-3000G
PAL625P
768 576
NTSC525P 640 480
1152 864
1400 1050
*1 Only when using a graphic accelerator board that is capable of displaying 852 480.
*2 This signal is converted to a 1024 dots 640 lines signal.
*3 The picture is displayed in the original resolution.
*4 The aspect ratio is 5:4. This signal is converted to a 960 dots 768 lines signal.
*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above.
*6 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port.
*7 Other screen modes (ZOOM and STADIUM) are available as well.
*8 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be unstable (jumpy).
If this occurs, please set the refresh rate of the external equipment to 60Hz.
*9 CVT standard compliant.
NOTE:
• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the
picture or the fine picture because of errors in synchronization of your computer.
• When a 1280 dots 1024 lines signal or 1600 dots 1200 lines signal is input to the monitor, the picture will be compressed.
• This monitor has a resolution of 1365 dots 768 lines. It is recommended that the input signal should be XGA, wide XGA, or
equivalent.
• With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal.
What is HDCP/HDCP technology?
HDCP is an acronym for High-bandwidth Digital Content Protection. High bandwidth Digital Content Protection (HDCP) is a
system for preventing illegal copying of video data sent over a Digital Visual Interface (DVI).
If you are unable to view material via the DVI input, this does not necessarily mean the PDP is not functioning properly. With
the implementation of HDCP, there may be cases in which certain content is protected with HDCP and might not be displayed
due to the decision/intention of the HDCP community (Digital Content Protection, LLC).
• "IBM PC/AT" and "XGA" are registered trademarks of International Business Machines, Inc. of the United States.
• "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States.
Downloaded From TV-Manual.com Manuals
Sync Polarity
Vertical Horizontal
frequency frequency
Horizontal
(Hz) (kHz)
60.0 49.7 – –
60.0 63.9
– –
50.0 31.4
NEG
59.9 31.5
NEG
60.0 53.7 POS
72.0 64.9
POS
60.0 65.3
NEG
75.0 82.3
NEG
85.0 93.9
NEG
Presence
Vertical Horizontal Vertical NORMAL
– – – – – – YES*
YES*
– – – – – –
YES*
NEG YES YES
NEG YES YES YES*
NEG YES YES
NEG YES YES
POS YES YES
POS YES YES
POS YES YES
En-43
Screen mode
RGB
select*
TRUE FULL
(4:3) (16:9)
3 – –
– – YES
4 – – YES – –
7 – – YES* 7 – –
7 7 640 480
– – YES*
1152 864
YES – – YES
YES – – YES – –
YES – – YES – –
YES – – YES – –
– –
YES – – YES
5 Memory
DVI
62
YES
29
YES
31
NO
32
NO
84
YES
85
YES
65
YES
71
YES
72
NO