Technical Specification; Dimensional Drawings - Wamsler ROOK Mode D'emploi

3. Place the steel cover on top and
insert the enclosed middle cover.
The following steps must be observed when converting the external air connection:
1. Drill out the existing 3mm holes
with a 6mm drill (6x)
2. Dismounting the blind cover by
removing the M8 screw.
3. Position the enclosed air con-
necting
4. And screw tight, with the M8
screw.

3. Technical specification

3.1 Dimensional drawings

3
Steel cover on top
1
3
28
Middle plate
2
4