Bradley Sentry SN2013/AST4 Mode D'emploi page 6

SN2013/AST4, SN2013/AST4-F, SN2033/AST4
1
Install Unit
A Remove Access panel and with
the help of another person, place
unit in position against both walls.
B
Ensure unit is level, shimming floor unit if
necessary. Mark the wall anchor locations.
2
Connect Water Supply to Valve Assembly
Connect stops to hot and cold water
A supply. Connect one end of each supply
hose to a stop and the other end to the
hot and cold inlets of the Navigator TMV
respectively as shown.
Do not turn on water until
Step 3 is completed!
6
Rough-in of plumbing lines and wall braces must be
completed before unit can be properly installed.
Water Supply Gang
Valve Assembly
OPTIONAL TEMPERED LINE CONNECTION: Connect stop
B
to supply. Connect one end of the supply hose to the stop
and the other end to the tempered line adapter in the gang
valve assembly as shown.
8/15/2014
C Install suitable wall anchors (supplied
by installer) for 3/8" bolts at the marked
locations. Secure unit to wall.
Red Tube
(to Aerator)
Green Tube
(to Aerator)
Black Tube
(to Aerator)
Navigator TMV
Cold Supply Inlet
Hot Supply Inlet
Bradley • 215-784 Rev. P; ECN 14-00-007
Installation
Water Supply Gang
Valve Assembly
OPTIONAL Tempered Line
Adapter Assembly (S39-804)
Braided
Hose
Stop Valve