Unpacking; Preparation And Connection - Aerial 5310-0016 Mode D'emploi

General safety information
WARNING! Electrocution!
Working on live components or water on
live components can cause life-threaten-
ing electrocution.
Avoid contact between water and

live components.
Before changing the location of the

dehumidifier and pump kit, switch it
off and then press and hold down
the button for manual pump out until
there is no more condensate water
flowing out of the hose. Then dis-
connect the mains plug.
Each time the pump kit is installed

or removed, ensure that the safety
relay for the
switched off and the mains cable is
disconnected.
Check that the pump kit cables are

not damaged.
Only allow the manufacturer or au-

thorised personnel to carry out work
on electric components.
WARNING! Risk of burn!
Only allow the manufacturer or au-

thorised personnel to carry out work
on internal components.
6

Unpacking

Procedure
1. Check that the package contents
are complete. Contact your stockist
in the event of damage or missing
contents.
2. Remove the packaging and dispose
of it in accordance with local regula-
tions.
7
Preparing the dehumidifier
The dehumidifier must be prepared for
the use of a pump kit. The following is an
example of the procedure. The setup
may vary slightly depending on the de-
humidifier, but the procedure is the
same. Pay attention to the operating in-
structions for the dehumidifier.
WARNING!
Electrocution may occur due to improper
or faulty connection to the power supply.

dehumidifier is

Procedure
1.
2.
The next step is to slide the cover sheet
in front of a notch to bypass the sensor
behind it. If the cover sheet is already in
front of the notch, the next step may be
skipped.
13
Preparation and connec-
tion
Electrocution!
Check that the connection cable is
compatible with the pump kit con-
nection on the dehumidifier.
Ensure that the connection cable is
undamaged.
Check that the mains cable has
been disconnected from the dehu-
midifier.
Remove the dehumidifier basin (if
there is one) and remove the dis-
charge hose from the discharge
nozzle on the dehumidifier.