Publicité
Les langues disponibles
Les langues disponibles
Performing treatment
Display
Is lit during warming up
Cover
Fill level display
Cover
Handle
1. Set the desired treatment time using the 10 and 1 buttons:
-
Button 1: input in 10-minute increments,
-
Button 10: input in 1-minute increments.
2. The display shows the treatment time selected.
3. Press the START button.
-
The thermometer symbol is lit (approx. 2 minutes).
-
The display shows the remaining treatment time.
-
By pressing the START button again, the treatment time that has al-
ready passed (memo function) is displayed.
-
If ionisation was switched on in the previous treatment, the LED in the
ION button is lit - ionisation is switched on.
After the end of the follow-up treatment, switch off appliance or prepare for
new treatment.
9.12
Refilling water boiler during ongoing
treatment
Checking fill level of the water boiler
It is simple to check the fill level of the water boiler when it is mounted in the
appliance.
1. Push the locking mechanism of the cover forwards.
The cover flips open automatically.
-
When the appliance is switched on, a symbol flashes in the upper display.
-
The treatment is paused.
2. Read the fill level from the fill level display.
NOTE: fill the water boiler before each treatment.
-
Please remember that any interruption and subsequent delay until treat-
ment resumes will extend the exposure time of the hair treatment(s).
-
This can have unforeseen and unintended consequences and lead to re-
sults with which the customer is not satisfied.
-
Take the extended exposure time into consideration.
Filling the water boiler
DANGER! Risk of burn injuries
The water boiler is hot when removed from the appliance. Only remove the
water boiler from the appliance by gripping the handle!
NOTE:
•
After 5 minutes, the appliance reverts to the start position.
•
The water boiler must therefore be filled and replaced in the appliance
within 5 minutes; otherwise the ongoing treatment will be stopped and
cannot be continued.
GB
47
Publicité
