Product Use - StreamLight TLR-7 sub Instructions D'utilisation

SWITCH OPERATION
The TLR-7 sub models feature ambidextrous rear switches. All models provide momentary or constant activation.
®
• A tap on either switch turns the unit "on" or "off".
• Press and hold either switch for momentary activation of the unit.
• NOTE: The TLR will not operate if the facecap is in "safe" mode.
Rear Switch Options
The TLR-7 sub has two versions of tail switch available, depending on user grip preference. The LO tail switch
®
presents the rear switch lower on either side of the trigger guard while the HI tail switch presents the rear switch
higher up on either side of the trigger guard. The LO and HI tail switches are interchangeable by removing the tail
screws using a 5/64" hex wrench. Ensure both actuators are in place on the tail switch before installation (see Tail
switch Actuator view below).
Strobe Enable/Disable
The TLR-7 sub ships from the factory with the strobe mode disabled. To enable strobe, starting from the "Off"
®
position, tap either switch very rapidly 9 times (within ¼ second per tap) and hold down on the 10th time. Hold
the switch until the light turns off (about one second) which indicates reprogramming was successful. Repeat the
procedure above to disable strobe mode.
Strobe Operation
The TLR-7 sub strobe mode can be activated by either switch. Within ¼ second, press either switch, release and
®
immediately re-press for strobe.
MAINTENANCE
The TLR rail clamp tension bolt requires an application of high quality gun oil to keep it rust free. Use a soft cloth
and mild detergent to clean the glass LED lens and keep it free of dirt and grime.
Note: Always avoid aggressive cleaning solutions as they may damage the TLR. If you shoot ammunition with an
exposed lead base on the bullets, the lens and facecap may become coated with lead. This may be removed from
the lens by rubbing with fine steel wool. It is extremely difficult to remove the lead coating from the facecap. Wrap
the facecap with electrical tape to avoid lead coating.
PRODUCT USE: Streamlight
sources. Use of Streamlight
manufacturer. Streamlight
Be sure to use only genuine Streamlight
NOTICE
Streamlight
try to repair the unit yourself. Send to a qualified service facility or return it to the factory.
High Switches
flashlights are intended for use as high intensity, heavy duty, and portable light
®
flashlights for any purpose other than as light sources is specifically discouraged by the
®
specifically disclaims liability for other than recommended use.
®
approved replacement parts, substitution may invalidate the product approval. Do not
®
Tail
Switch
Actuator
Low Switches
replacement parts. To assure product safety always use
®