Table des Matières
Publicité
C. Guide de démarrage rapide
*Before you plug in this appliance, follow these instructions*
1. Empty
component packet and
any other debris.
2. Add pellets and close
lid.
1. After the exhaust blower has stopped; quickly turn the dial from OFF to HI two times:
Priming is only needed for fi rst fi re or starting fi re on empty hopper.
NOTE: The prime function is only required during initial set up of the unit, or after the unit has
alarmed out due to an empty hopper. Priming while under normal operating conditions will cause
the fi re pot to overfi ll.
1. While thermostat is in RUN mode, the
set temperature can be temporarily
changed by pressing UP.
2. Choose Setting:
**Appliance will not turn on unless target
temperature is a higher temperature than the
room temperature.
• LO – HI*
• Green LIGHT will begin fl ashing
6
QUICK START GUIDE
fi re
box
of
• The LIGHT will turn solid green and pellets will feed. Wait for 2 minutes
• If the LIGHT did not turn solid green:
- Turn dial back to OFF
- Unplug appliance, plug it back in and repeat
and stove will start
LO
LO
HI
It may take as long as 10
minutes to achieve a fi re in
the fi re pot. Turning the knob
or thermostat to off during this
time will interrupt the startup
process.
*For
fi rst
recommends running on HI
for fi rst 30 minutes
April 05, 2021
8106-804B
3. Turn DIAL to OFF
4. Plug in the appliance
• Exhaust blower will run for about 45
Seconds (wait for it to stop before
priming)
• Green light will start fl ashing
5. Ensure thermostat is connected properly
per included instructions.
LO
HI
fi re,
HHT
LO
Control Panel
HI
Light
Dial
HI
Trim
05/22
Publicité
Table des Matières
