Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en
en
7 | MTS 6513 VCI | Product Description
4.5
MTS 6513 Connectors and Controls
A number of standard connectors and controls are
available on the MTS 6513 to facilitate operation and
communication with vehicles and workshop networks.
These connectors and controls are shown in the fol-
lowing illustrations.
1
3
4
Item
Description
1
LCD Display
2
Keypad
3
Power LED
4
USB Connector for (optional) Wi-Fi Interface
5
Reset Tab
6
Micro SD Card
7
USB mini "B" Connector
8
15P DLC Cable connector
|
16992000121
January 2017
2
7
5
6
8
4.6
Universal Serial Bus (USB)
The MTS 6513 has a fixed USB configuration which
cannot be changed. This ensures that the MTS 6513
can always be connected to a single PC running the VCI
Manager software so you can configure LAN or WLAN
settings required by your local network. In addition, it
is important to note that a USB connection is required
to configure and update the firmware on the MTS 6513
VCI.
4.7
Wireless Local Area Network (WLAN)
The 802.11 b/g/n WLAN connection on the MTS 6513
is set up and configured while the device is connected
over USB to a PC running the VCI Manager software.
4.8
VCI Manager Software
The VCI Manager software is a host computer applica-
tion which runs on the Microsoft Windows operating
system to configure and update VCIs. The VCI Manager
software allows the configuration of VCI-to-host PC
communications and facilitates VCI firmware updates.
4.9
J2534 Pass-Thru Support
The MTS 6513 works with an OEM supplied J2534 PC
computer applications (PC program) for ECU Reflashing
and diagnostic applications.
The MTS 6513 supports pass-thru programming of
the flash calibration files that are stored in a vehicle
onboard controller (e.g., PCM, ABS, VTD). Refer to
specific operating instructions provided by the OEM
supplied J2534 PC application.
The MTS 6513 design is based on the SAE J2534
Pass-Thru and ISO 22900 Modular Vehicle Interface
standards, where the MTS 6513 VCI may be compatib-
le with other software applications that use these API
standards.
4.10
Additional MTS 6513 VCI Features
4.10.1
Data Link Connector and Cable
Communication between the MTS 6513 and the
vehicle's electronic systems is through the 15-pin to 16-
pin Data Link Connector (DLC) cable that is connected
to the top center of the MTS 6513.
4.10.2
Power Source
The MTS 6513 is intended to be powered from the ve-
hicle battery via the DLC Cable. The VCI may also be
powered using the USB cable connected to your PC.
Typically you use USB power when you are first confi-
guring the VCI, updating software, and during testing
of the VCI. Important Note - The VCI must be powered
Robert Bosch GmbH
Publicité
Table des Matières
