Klarstein 10012196 Mode D'emploi page 11

Warning Possible cause
E0 An unsuitable pot/pan is on the induction
zone or the diameter of the pot/pan is less
than 12 cm.
E1 Bad connection of the induction hob/ faulty
electrical circuit.
E2 Problem with the temperature sensor.
E3 Voltage is too high.
E4 Voltage is too low.
E5 Protection against overheating - the cooktop
is too hot.
Problem with the fan, the air in-take/outflow
E6
is blocked.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailed information about recycling of this product, please contact your local council or your
household waste disposal service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
11
Troubleshooting
Hints on Disposal
Declaration of Conformity
Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Contact an authorized service center.
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean the
openings. Afterwards, restart the appliance. If
the problem persists, contact an authorized
service center.