shark EZ ROBOT 900S Série Guide D'utilisation page 8

MAINTENANCE
EMPTYING THE BASE DUST BIN
The Base Dust Bin holds up to 15 days' worth of
dust and debris. Empty the bin when the debris
level approaches the max fill line.
To detach the bin, press and hold the Release
button on the top and slide out the bin.
s h a r kc l e a n . c o m
To empty the bin, hold it over the trash, then press
the release button with the trash can icon on the
bottom of the bin. The bin lid will open, releasing
dust and debris. Lightly tap the dust bin against
the inside of the trash receptacle to knock off any
remaining debris. Reinstall the bin by sliding it into
the slot in the base until it clicks into place.
MAINTENANCE
CLEANING AND REPLACING THE ROBOT FILTER
For best results, regularly clean and replace the filter in the robot. See sharkaccessories.com
for replacement filters.
IMPORTANT: DO NOT use water to clean the robot filter.
Remove and empty the robot dust bin. Clean any
hair or debris off the Anti-Tangle Comb on the
back of the dust bin.
Lightly tap the filter to remove dust and debris.
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the robot dust bin, then
slide the dust bin back into the robot.
s h a r kc l e a n . c o m