Faber T-AIR KL A90 Manuel D'utilisation page 7

F Short
Long press with
all loads off (mo-
tor and lights)
G Short
Long press with
all loads off (mo-
tor and lights)
Recommended device pairing sequence:
1 - K-Link Mode (See remote control manual)
2 - K-Link Pairing (See hood manual)
3 - Remote Control-Hood Pairing (See remote control manual)
4 - K-Link Pairing (See hood manual)
5 - Cooktop-Hood Pairing (See induction cooktop manual)
Wi-Fi connection
Activates/Deactivates the Wi-Fi Connection function.
Note: the Wi-Fi function is automatically activated when the user re-
quests the Wi-Fi configuration procedure.
Wi-Fi configuration
Activates/Deactivates the Wi-Fi set-up procedure.
Before starting the procedure use the Faber Cloud App to register
with the IOT Faber system. Then follow the instructions to add a new
device and register the domestic router.
If the procedure is not successfully completed within a few minutes,
deactivate it by long pressing the key again, then make another at-
tempt. The hood will nonetheless abandon the procedure if it is not
successfully completed within 15 minutes.
AUTO Mode
Activates/Deactivates the Automatic operating mode.
AUTO mode is deactivated whenever any other keys are pressed.
AUTO mode is activated when the key is pressed or the Paired In-
duction Cooktop is turned on. The hood speed is automatically set
using the highest power level present on the hob. When the induction
cooktop is turned off the last activated speed is held for 5 seconds,
then speed 1 for 15 minutes. Once the 15 minutes have passed the
motor turns off. The light status does not change.
Thanks to the presence of the Air Quality Sensor an algorithm is
able to modulate the speed based on the intake air quality level.
CAUTION: The algorithm function is optimised for the most common
types of cooking. Uncommon preparations may produce a non-optim-
ised response.
Activates/Deactivates the Activated Carbon Filters alarm.
Flashing:
connection to domestic
network in progress.
Fixed:
Wi-Fi connection activ-
ated
The display shows an
animation:
configuration procedure
in progress.
Upon confirmation that
the procedure was suc-
cessful, all the LEDs will
light up for 2 seconds.
Fixed:
AUTO mode activated.
Off:
AUTO mode temporarily
deactivated.
With the motor off, the
display shows F + 2
multiple times altern-
ately:
alarm activated.
With the motor off, the
display shows F + 0
multiple times altern-
ately:
alarm deactivated.
7