Hilti DD VP-U Mode D'emploi Original page 6

1.3 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Type designation
Generation
Serial no.
2 Safety
2.1 Additional safety instructions
▶ Also study all instructions relating to safety and operation in the corresponding operating instructions of
the system products (vacuum base plate, drill stand, diamond core drilling machine).
▶ Keep the air vents of the pump free from dirt and dust. Ensure adequate free space at the air discharge
to prevent overheating.
▶ Stand the pump on a dry, horizontal surface for operation and secure the vacuum pump so that it cannot
slip out of position.
▶ In the event of failure of the electric supply or malfunction of the product, the vacuum is maintained for
a short time. Stop working immediately and check the pressure gages on vacuum pump and vacuum
base plate. Secure the drilling system so that nothing can fall.
▶ Do not tamper with or modify the product in any way.
▶ Use only Hilti Hilti spare parts.
▶ Always empty the water separator before transporting the vacuum pump.
▶ Ensure that the working area is well lit.
▶ At regular intervals, check the vacuum hose for leaks and damage and replace faulty hoses without
delay.
▶ Avoid kinks in the vacuum hose.
▶ Keep the supply cord, extension cord, water hose and vacuum hose away from rotating parts of the
machine.
▶ This product is not intended for use by persons (including children) with physical, sensory or mental
disabilities or persons lacking the appropriate experience and/or knowledge. These persons must receive
instruction in safe handling of the appliance and must be supervised throughout their use of the appliance
by a responsible person.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged. If the machine's supply cord is damaged it must be replaced with a specially
prepared and approved supply cord available from Hilti Customer Service. Check extension cords at
regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension
cord if it is damaged while working. Disconnect the supply cord plug from the power outlet. Damaged
supply cords or extension cords present a risk of electric shock.
2 English
DD VP-U
01
416186
*416186*