Use Precautions; Main Functions - air&me Humini Guide D'utilisation

COMPONENTS (SEE PAGE 2)
Mist outlet
1
Top Cover
2
Water tank
3
Water Cover
4
Air outlet
5

USE PRECAUTIONS

• Never connect the appliance when the tank is completely empty.
• Fill the tank with tap water or demineralised water. Do not fill the tank with softened water
with a salt softener.
• Make sure the product is placed on a dry, level surface and 10 cm away from the wall.
• Make sure that the removable filter and the tank are correctly positioned and depressed.
• Do not remove the float from the tank, as this will prevent the unit from starting.
• If you want to move the air humidifier, make sure to hold the appliance base and not the
tank.
• Do not put essential oils directly in the tank; it will damage the components.
12
Ultrasonic membrane
6
Housing
7
Power supply output
8
ON/OFF button
9
Power adapter
10
FILLING THE TANK (SEE PAGE 3)
Make sure that the device is switched off.
Remove the tank from its base by lifting it from the back.
1
Turn the tank over, unscrew the cap and fill it with cold water. Do not fill it with hot water:
2
this will cause leaks.
Close the cap tightly in a clockwise direction.
3
Replace the tank on its base.
4
OPERATING INSTRUCTIONS
1. Fill the tank with water.
2. Plug the power cord into the mains.
3. Switch the appliance on using the ON-OFF button on the front panel.
4. Press the button again to activate the first or second speed. Press the button 3 times to switch the
appliance off.
5. The humidifier will automatically turn off when the tank is empty.

MAIN FUNCTIONS

HUMIDIFYING POWER:
The main button is used to switch on the appliance and adjust its humidifying power:
• Minimum power: Press the button once.
• Medium power: Press the button twice.
At full power, the mist produced may condense around the appliance and give the impression
of a tank leak. To avoid this phenomenon, reduce the diffusion power and/or place the humi-
difier towards a heat source (at about 1 meter).
13