Function With 12 V Operation; Tips For The Best Cooling Output And Energy Saving; Exchanging The 12 V Fuse; Troubleshooting - Crivit REK 230 D2 Instructions D'utilisation Et Consignes De Sécurité

Operation / Tips for the best cooling ... / Exchanging the... / Troubleshooting
Turn the cooling output switch
position. This turns the coolbox off.
Note: If you want to reach a Delta T (Delta T =
difference between outside temperature and inside
temperature) of up to 17 °C and thereby a lower
inside temperature than is possible in the "eco" nor-
mal operation, turn the cooling output switch
the "MAX" position. Please note that in this case
more energy will be consumed than in normal
operation.
After the operation with 230 V function has been
completed, disconnect the mains plug from the
socket.

Function with 12 V operation

CAUTION! The temperature controller on the
front of the lid is only suited to 230 V operation
and it does not function in 12 V operation.
When operating with a 12 V power supply, the
cooling unit always produces a temperature
difference from the ambient temperature of up
to 17 °C. The cooling output can not be con-
trolled by means of the temperature controller
on the front of the lid.
Tips for the best cooling output
and energy saving
Select a well ventilated location protected from
sunshine.
Only place pre-cooled contents into the cool-
box.
Do not open the coolbox longer than necessary.
Don't leave the lid open longer than necessary.
Ensure that the coolbox is not packed too
full and that the air can circulate adequately
between the coolbox contents.
In order that a high level of energy saving can
be achieved, normal operation (cooling output
switch in the "eco" position) is recom-
3
mended for longer periods of use in 230 V
operation.
to the "OFF"
3
See also fig. C.
to
3
In the event of a malfunction, first verify you cor-
rectly followed the instructions for using the cool
box. Also check:
– Is the connection cable correctly connected
– Have you set up the coolbox in such a way
– Is the fuse in the plug of the 12 V connection
– Check the position of the cooling output
If you can not rectify the malfunction on your own,
please contact our Customer Service (see chapter
on "Service").

Exchanging the 12 V fuse

To replace the 12 V fuse
adjustment sleeve from the plug, turning
7
counter-clockwise.
Unscrew the screw with a suitable Phillips
5
screwdriver from the top half of the housing
Lift the top half of the housing from the bot-
6
tom half .
9
Lift the contact pin carefully out of the hous-
11
ing section. The fuse
10
Note: If the thin metal connection in the mid-
dle between the two metal caps is broken, then
the fuse is defective and must be replaced.
10
Press the contact spring
insert the new fuse carefully into the groove
10
provided for it. Now place the rear edge of the
contact pin on the front metal cap of the fuse
11
. By releasing the contact spring
10
and contact pin are located in the groove.
10 11
Screw the top and bottom halves of the housing
together again, reattach the red adapter
6 9
sleeve and turn clockwise to tighten. The plug
7
is now ready for operation.

Troubleshooting

and does your car cigarette lighter / domestic
socket function properly?
that the air can circulate freely and that venting
of the cooling unit can occur?
cable OK?
switch on the front of the lid.
3
, unscrew the red
10
.
6
can now be removed.
backwards and
8
, the fuse
8
GB 33