Trumpf TruConvert DC 1030 Manuel Opérateur page 87

Messages d'alarme
Number Message
40300 RS-485 communication alarm
40301 RS-485 communication alarm
40302 BMS communication timeout has occured.
40303 RS-485 communication alarm
40412 Software versions of system control and module(s) do not match.
40413 Software versions of system control and module(s) do not match.
40414 Software versions of system control and module(s) do not match.
40415 Software versions of system control and module(s) do not match.
40416 Software versions of system control and module(s) do not match.
40304 No slave module was found, please check RS-485 connection(s).
40305 Number of or combination of connected slave types not supported.
60090 Battery overvoltage
60093 DC link overvoltage
60102 DC link voltage too low for operation
60700 Auxiliary supply overvoltage
60142 Battery undervoltage
60703 Auxiliary supply undervoltage
60145 Wrong polarity on DC terminal detected
60132 RS-485 communication alarm
60129 Battery voltage under threshold setting
60150 Battery voltage over threshold setting
60168 Ambient temperature over allowed range
60186 Ambient temperature under allowed range
60192 Fan defective or stuck
Messages d'alarme
Messages d'avertissement
Number Message
10016 Powerfail of 24 V auxiliarysupply has been detected
11000 battery voltage < minimum reference or battery voltage > maximum
reference
Messages d'avertissement
A67-0147-00.BKfr-0
01-00
2021-08-17
Caused by
System control
System control
System control
System control
System control
System control
System control
System control
System control
System control
System control
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
DC-DC module
Caused by
System control
DC-DC module
Recherche des erreurs
Tab. 22
Tab. 23
81