Batteries; Installing Batteries - VINCENT RC-572 Manuel D'utilisation

The battery status indicator
gives you an idea about the battery charge status. When the batteries are
running low, this symbol flashes. The unit functions will be locked until
fresh batteries are installed. Replace the batteries as soon as possible to
ensure perfect performance. The remote control retains all data when bat-
teries have run out or while you replace them.

Installing Batteries

1. Open and remove the battery compartment cover by applying light
pressure on the point labelled "OPEN" and sliding the cover in the
arrow direction.
2. If necessary, remove used up batteries and insert 3 AAA batteries
matching the polarity as indicated on the bottom of the battery
compartment.
3. Close the battery compartment cover.
The batteries must be inserted correctly taking note of the
polarity, which is marked in the inside of the battery com-
partment.
In order to make full use of the batteries' lifetime, do not mix new and
used batteries. Make sure that you insert batteries of the same type.
Some batteries are rechargeable, others are not however. Take note
of the precautions and instructions that are included on all batteries.
Remove the batteries if the remote control is not going to be used for
a long time. Under no circumstances must batteries be short-circuited,
taken apart or heated up.
For environmental reasons, used batteries should be disposed of in
accordance with local environmental regulations and not put with
domestic waste.
Use only AAA (LR3) size batteries.
Vincent
46

BATTERIES

in the top right corner of the display