Finishing Trim - Regency P36E-NG4 Guide D'installation Et D'utilisation

®
REGENCY OPTIONS
NOTE: Remove both the Flush Louvers or Bay Louvers and
the Flush Front or Bay Front prior to installing the

Finishing Trim.

1) Install the Finishing Trim sides as shown in the Schéma, line
up the holes in the side trim with the holes in the fi rebox side.
2) Secure with 2 screws per side.
3) Loosen the 3 screws in the top inside edge of the fi rebox.
4) Slide the Finishing Trim Top over the Side Trim pieces and
fi t the bottom bracket slots over the screws. Tighten the 3
screws to secure.
5) Loosen the 2 screws on the hinge bracket on both the left
and right side of the louver.
6) Hook the bottom fi nishing trim to the side trims and snap
in.
7) Tighten the 2 screws on the left and right hinge bracket to
secure.
54
FINISHING TRIM
P36E-4 Foyer à évent direct à dégagement zéro