Maintenance; Idle Speed Adjustment - Maruyama EH23DSL Manuel Du Propriétaire/De L'utilisateur

Folding procedure
1. First stop the engine. Next attach the blade cover.
2. Turn the clamp knob counter clockwise until the
clamp knob stops. Folding the unit is not possible
without the clamp knob completely loosend.
3. Hold the handle securety, and then fold the blades
approximately 180 degrees while pushing the lock
pin downward. Do not touch the lock lever except
when folding the blades.
4. After folding the unit, tighten the clamp knob
firmly and fix the gearcase. When tightening the
clamp knob make sure that both racks are
engaged.

Maintenance

Maintenance, replacement or repair of emission
control devices and systems may be performed by
any repair establishment or individual; however,
warranty repairs must be performed by a dealer or
s e r v i c e c e n t e r a u t h o r i z e d b y M a r u y a m a
Manufacturing Company, Inc. The use of parts that
are not equivalent in performance and durability to
authorized parts may impair the effectiveness of the
emission control system and may have a bearing on
the outcome of a warranty claim.
Maintenance on today's low-emission engines is
even more critical for longest life and best
performance. particularly critical are air and fuel
filters, spark plug heat range, cooling air intake
area and proper gaps of coil and plug.

Idle Speed Adjustment

This Hedge trimmer is equipped with non-adjustable
fuel mixture carburetor. The engine idle speed is the
only adjustment for the operator.
• I d l e s p e e d a d j u s t m e n t s h o u l d b e
checked each time the unit is operated.
POTENTIAL HAZARD
• E n g i n e m u s t b e r u n n i n g t o m a k e
carburetor adjustments.
• When engine is r unning, blades are
moving and other parts are moving.
WHAT CAN HAPPEN
• Contact with moving blades or other
moving par ts could cause serious
personal injur y or death.
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away from
cutting head and other moving parts.
• Keep all bystanders and pets away from
u n i t w h i l e m a k i n g c a r b u r e t o r
adjustments.
The cutting blades may be moving during idle speed
adjustment. Wear the recommended personal protec-
tive equipment and observe all safety instructions.
Keep hands and body away from the blades.
When the throttle trigger is released, the engine should
return to an idle speed between 2700 and 3300 RPM,
or just below the clutch engagement speed. The blades
must not move and the engine should not stall (stop
running) at engine idle speed.
To adjust the engine idle speed, rotate the idle speed
adjustment screw on the carburetor.
− US-20 −
WARNING
WARNING