Meec tools 020688 Mode D'emploi page 33

• If dust extraction and dust
collection equipment is
available, this should be
connected and used
correctly. The use of such
devices can reduce the risk of
dust-related problems.
USING AND LOOKING AFTER
POWER TOOLS
• Do not force the power tool.
Use the correct power tool
for the planned work. The
correct power tool will work
better and more safely when
used with the load for which
it was designed.
• Do not use the power tool if
it cannot be switched on and
off with the power switch.
Power tools that cannot be
controlled with the power
switch are dangerous and
must be repaired.
• Unplug the plug from the
power point before making
any adjustments, replacing
accessories or putting the
tool away. These safety
precautions reduce the risk
of accidently starting the
power tool.
• Store power tools out of the
reach of children when not in
use. Never allow anyone who
is unfamiliar with the power
tool and these instructions to
use the tool. Power tools are
dangerous in the hands of
inexperienced users.
• Keep the power tool properly
maintained. Check that
moving parts are not
misaligned, jammed or loose,
and that there are no other
factors that could affect the
safe use of the tool. If the
power tool is damaged, it
must be repaired before being
used again. Many accidents
are caused by poorly
maintained power tools.
• Make sure that cutting tools
are sharp and clean. Properly
maintained cutting tools
with sharp cutting edges are
less likely to jam and are
easier to control.
• Use the power tool,
accessories and bits etc.,
in accordance with these
instructions, taking into
account the actual working
conditions and the work that
EN
33