Maintenance; To Clean The Pressure Relief Valve; To Clean The Seal Holder For Pressure Relief Valve; To Clean The Container - Menuett 006783 Instructions D'utilisation

3
Set the time with the +/- buttons. Each push on the
buttons increases or decreases time with 10 minutes.
If no other button is pushed, the product starts after
10 seconds.
Note! The countdown in the display starts when the pres-
sure increases in the product.
3.8.4 To use the manual setting with delay
1
Push the button for manual setting. The status lights
for Manual setting and High comes on. The display
shows the number 30.
2
Push the delay timer button. The status light Delay
Timer and the time flashes in the display.
3
Set the required time with the +/- buttons. Each push
on the buttons increases or decreases time with 10
minutes. After 10 seconds the total cooking time will
show on the display and the countdown starts.
3.8.5 To set the pressure for manual setting
1
Push the button for manual setting. The status lights
for Manual setting and High comes on. The display
shows the number 30.
2
Push the pressure setting button. The status light for
High goes off and the light for Low comes on. Push
the button 1 more time to select Medium pressure. If
no other button is pushed, the product starts after 10
seconds.
Note! The countdown in the display starts when the pres-
sure increases in the product.
4

Maintenance

● Keep the pan clean for best functionality and lifespan.
Clean the pressure cooker often and remove any grease
and scraps.
● Clean the pan with hot water and a mild detergent.
● Do not use metal utensils, abrasive or scratching utensils
when cleaning, they can damage the surface of the pan.
● Store the pressure cooker at least 30 cm from other
kitchen appliances.
31

4.1 To clean the pressure relief valve

Note! Clean the pressure relief valve once every month.
1
Pull the pressure relief valve out of the lid.
2
Clean the inside and outside of the pressure relief
valve with a brush or cloth.
4.2 To clean the seal holder for
pressure relief valve
Note! Clean the seal holder every other month.
1
Clean the seal holder with hot water, washing-up
liquid and a brush.
2
Remove all residue.

4.3 To clean the container

Note! Clean the container after each use.
● Empty the container and wipe dry with a clean cloth.
4.4 To clean the water collection
container
Note! Clean the water collection container after each use.
● Empty the container and wipe dry with a clean cloth.
5

Disposal

5.1 To discard the product

Make sure that you follow local regulations when you
discard the product. Do not burn the product.
6

Technical data

Technical data
Rated voltage
Output
Volume
Pan diameter
Operating pressure
Warming temperature
230 V ~ 50 Hz
1000 W
5.5 l
220 mm
1.6 bar/160 kPa
60–800C
2022_001