To Open The Lid; To Close The Lid; To Do A Check Of The Seal; To Do A Check Of The Float Valve And The Pressure Relief Valve - Menuett 006783 Instructions D'utilisation

3.2 To open the lid

3.2.1 To open the lid on a pressurized cooker
Warning! Do not open the lid until the pressure in the
pan is fully relieved. Do not force the lid.
Warning! Do not open the pressure relief valve
immediately after cooking a large amount of food. Leave the
pressure cooker in keep warm mode for a short while before
opening the lid.
1
Switch off the pressure cooker and disconnect the
plug.
2
Do 1 of the procedures that follow.
A. Turn the pressure relief valve to the open position
(A) to relieve the pressure until the float sinks (for
non-liquid flood). (Figure 3)
Warning! Keep your hands and face away from the
steam outlet - risk of scalding, serious personal injury
B. Allow the pressure cooker to cool until the float
sinks. Turn the lid handle counterclockwise 30°,
so that the marking on the edge of the lid is in
line with the marking on the container (A).
(Figure 4)
3.2.2 To open the lid on a cooker without
pressure/before use
1
Turn the lid handle counterclockwise 30°, so that the
marking on the edge of the lid is in line with the
marking on the container lid.
2
Remove the lid.

3.3 To close the lid

1
Turn the lid handle clockwise 30°, so that the padlock
marking on the edge of the lid is in line with the
marking on the container. (B)
2
Turn the pressure relief valve to closed position (B).

3.4 To do a check of the seal

1
Remove the lid. Refer to "3.2.2 To open the lid on a
cooker without pressure/before use" on page 29
2
Pull out the seal. (Figure 5)
29
Note! Handle the seal with care. If the seal becomes dam-
aged or deformed, it will seal poorly and the pressure in the
cooker will be reduced.
3
Inspect the seal for damage.
Caution! Do not use the pressure cooker if the seal is
damaged. Contact the retailer for a new seal.
4
Install the seal in the opposite sequence.
3.5 To do a check of the float valve
and the pressure relief valve
1
Remove the lid. Refer to "3.2.2 To open the lid on a
cooker without pressure/before use" on page 29
2
Make sure that the float valve (A) and the pressure
relief valve (B) are not blocked and that they can
move freely. (Figure 6)
Warning! The pressure relief valve must not be
replaced or pressed down with a heavy object.
3.6 To remove the water collection
container
1
Remove the water collection container. Make sure
that it is clean and undamaged.
2
Install in the opposite sequence. (Figure 7)

3.7 To use the product

3.7.1 To prepare for cooking
1
Remove the lid. Refer to "3.2.2 To open the lid on a
cooker without pressure/before use" on page 29
2
Do a check of the seal. Refer to "3.4 To do a check of
the seal" on page 29.
3
Do a check of the float valve and the pressure relief
valve. Refer to "3.5 To do a check of the float valve
and the pressure relief valve" on page 29.
4
Lift out the container and put the food and water in it.
Caution! Do not fill the container over the Max mark-
ing. If the Max marking is exceeded it can cause a malfunc-
tion or prevent the food from being properly cooked.
2022_001