Assembly; Specifications; Operation - Denios FZ 600 Mode D'emploi

The P 360 drum gripper
-
is for vertically lifting and transporting 200litre steel drums or 220 litre plastic L-ring drums.

Assembly

Preparation
The drum lifting device must be hooked on and lifted up by a crane eye.
Care must be taken that the drums to be lifted are dry and oil- or grease-free!
It requires two people to be able to lift a drum with the drum lifting devices:
Person 1 use of the crane
Person 2 to fix the holding tongues on the rim of the drum
Important:
Danger of injury by crushing when the drum is raised!
When lifting keep hands out of the trapping area!

Specifications

Safe working load: 350 kg

Operation

Loading
Drive up centrally to the drum to be loaded with the drum lifting device.
-
Lower the retaining tongues over the rim of the drum. Make sure that the tongues have a grip under the rim of
-
the drum
Raise slightly, adjust until the retaining tongues are touching the drum.
-
Lift the drum (the retaining tongues must rest against the drum under the rim during the lifting procedure).
-
By the effect of gravity the drum is held fast by the retaining tongues.
Moving the drums
Only move raised drums at walking speed
-
Take the greatest care when moving over uneven ground
-
There is the danger that the load will start rocking even with careful handling
-
Do not walk under suspended loads!
-
Unloading
As soon as the drum touches the ground after lowering it is automatically released by the drum lifting device.
Exception: Drum tongs FZ 500 H, with these the stop mechanism has to be unlocked to release the drum.
Fasshebegeräte
115256, 115261, 115266, 164399,
164397, 115188, 115187, 164400, 164641
Seite 8 von 16 Seiten Ausgabe05/2010