Home Skinovations Silk'n Pro AS104779A Mode D'emploi page 3

10. Set the energy level. If the energy level should be higher than the lowest, press the ENERGY LEVEL
SETTING BUTTONS using the "-" or "+" to respectively decrease or increase the energy level, until
the desired energy level is set and represented by 3 energy level indicator lights (For details see "Energy
Level" chapter inside this user manual).
11. Apply the TREATMENT SURFACE to the skin, making sure the skin is spread evenly and smoothly. As
soon as the TREATMENT SURFACE is in full contact with the skin, the READY INDICATOR LIGHT will
start blinking.
12. Press the PULSE BUTTON. The device will first determine the color of your skin. If the color of the skin
is light enough for safe application, the device will flash a pulse of light onto your skin, and the READY
INDICATOR LIGHT will turn off. You will see a bright flash of light and simultaneously hear a subtle pop
sound, which is a normal noise for the device. You will feel a mild sensation of warmth and tingling.
Silk'n Pro™ will immediately recharge for the next pulse. After 3.5 seconds the READY INDICATOR
LIGHT will turn on again.
13. Remove the TREATMENT SURFACE from the treated area of skin.
14. Move the TREATMENT SURFACE to another area of skin. Use the pressure marks the device just
made on your skin to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps
between pulses.
Try to avoid overlapping pulses!
Warning: Do not treat the same area of skin more than
once per hair removal session!
Treating the same area of skin more than once per session
increases the likelihood of adverse effects.
15. Repeat the process until the entire treatment area is covered.
If your skin blisters or burns, STOP USE IMMEDIATELY!
2
All manuals and user guides at all-guides.com