Publicité
Les langues disponibles
Les langues disponibles
Fax +32 030 9904733
DESCRIPTION OF THE APPLIANCE
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Operate in the following way to use the convector heater:
1)
Insert the plug in the socket
2)
Turn the thermostat knob (1) clockwise to the position corresponding to the desired
temperature.
3)
To switch the appliance on, press switch (2) to heat using 1250 W, or switch (3) to heat at
750W or both to heat at 2000W.
4)
To start the fan (4) press switch (4).
5)
The pilot light comes on an goes ot when the appliances reaches the set temperature
6)
To switch the appliance off, return the switch buttons to the "0" pos. and turn the thermostat
knob anticlockwise. Remove the plug from the power socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods.
Anti-frost device
Insert the plug into the power socket, press switches (2) and (3) and turn the thermostat knob to the
anti-frost position (*): this permits convector heater switching on when the ambient temperature falls
below +5°C.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
1)
Thermostat knob
2)
1250 W Switch
3)
750 W switch
4)
Fan switch
10
28
/
Assembly page 10/28
Publicité
