Bosch BGS41 Serie Mode D'emploi page 46

Spare parts and optional accessories
A BBZ123HD hard-floor nozzle
For vacuuming smooth floors
(parquet, tiles, terracotta, etc.)
B BBZ124HD hard-floor nozzle
Includes two rotating brush rollers
For caring for expensive hard floors
and for the improved collection of
coarse dirt.
Before using the appliance for the first
time
1*
Figure
‡
Push the handle onto the suction hose and lock it in
place.
Starting the appliance
2
Figure
‡
Push the suction-hose adapter into the air intake
opening on the appliance and lock it in place. You
will hear an audible 'click'.
3*
Figure
a) Telescopic tube without accessory connection:
Push the handle into the telescopic tube.
b) Telescopic tube with accessory connection:
Push the handle into the telescopic tube until it
locks into place.
4*
Figure
a) Nozzle without accessory connection:
Push the telescopic tube into the connecting piece
of the floor nozzle.
b) Nozzle with accessory connection:
Push the telescopic tube into the connecting piece
of the floor nozzle until it locks in place.
5*
Figure
‡
Unlock the telescopic tube by moving the sliding
switch or adjusting sleeve in the direction of the ar-
row, and adjust it to the desired length. The slide
resistance on carpet is at its lowest when the tel-
escopic tube has been fully extended.
6*
Figure
‡
Attach the accessories holder to the multi-purpose
nozzle and clip it onto the suction pipe/telescopic
tube.
7
Figure
‡
Holding the mains cable by the plug, pull it out to
the required length and plug the plug into the mains
socket.
46
8
Figure
‡
To switch the vacuum cleaner on or off, press the
ON/OFF button.
Controlling the suction level
9
Figure Controlling the suction power
Turn the rotary control to infinitely adjust the suction
level to the level required.
min - For vacuuming curtains and delicate textiles
- For vacuuming upholstered furniture and cush-
ions
- For vacuuming delicate rugs und for daily vacu-
uming of lightly soiled floors
- For vacuuming durable floor coverings
max - For vacuuming hard floors and heavily soiled
rugs and carpets
10*
Figure Telescopic tube with sliding switch and aux-
iliary air control
The suction power can also be adjusted by turning the
auxiliary air control switch in the direction of the arrow.
„ Auxiliary air control switch open
=> suction power reduced
„ Auxiliary air control switch closed
=> maximum suction power
Vacuum-cleaning
!
Caution
Floor nozzles are subject to a certain amount of
wear, depending on the type of hard floors you have
(e.g. rough, rustic tiles). You should therefore check
the underside of the floor nozzle at regular intervals.
Worn undersides of floor nozzles may have sharp
edges that can damage delicate hard floors, such as
parquet or linoleum. The manufacturer does not ac-
cept any responsibility for damage caused by worn
floor nozzles.
11
Figure
Set the switchable floor nozzle as follows:
„ Rugs and carpets =>
„ Hard floors/parquet =>
If you are vacuuming up relatively large particles, make
sure that you vacuum them up successively and care-
fully to ensure that the floor nozzle's air intake duct
does not become blocked.
If necessary, you should lift up the nozzle in order to
better vacuum up the dirt particles.
* Dependent on model