Mig/Mag Welding. Installation And Start-Up - GALAGAR SMART 200 MP Manuel Technique D'instructions

3.2 MIG/MAG WELDING. INSTALLATION AND START-UP

3.2.1 INSTALLATION OF STANDARD MIG/MAG SYSTEM WITH GAS. TORCH TO POSITIVE POLE.
3.2.2 INSTALLATION OF (FCAW) MIG/MAG SYSTEM WITHOUT GAS. TORCH TO NEGATIVE POLE.
3.2.3. MIG/MAG SYSTEM START-UP.
1) Make sure the mains voltage is 230 V.
2) Connect supply cable with the suitable plug to the relevant single-phase tap. See section 2.2.
3) Change the polarity if it is necessary. The torch must be to positive in MIG/MAG with gas process.
4) If the material to be welded is aluminium, change the flexible cable and the wire guide tube for the graphite
cable with the torch totally stretched.
5) Depending on the wire diameter, fit the groove of the suitable driving wheel to the work to be carried out.
6) Choose suitable gas to wire type to be welded. If it has a mobile workstation, check that the gas bottle is securely
held by the bottle-holder system. Above all check that the safety chain is perfectly fastened.
7) Install the pressure-reducing valve and connect gas hose checking that there are no leakages, throughout the
whole circuit.
8) Fit the wire reel into the support axle.
9) Fit the welding wire into the driving system. Do not force the wire pressure handle, as if this is too tight, the motor
remains on overload and does not reach the maximum speed, and if the handle is too slack, the wire could slip.
10) Once the wire has been fitted, we can then conect the MIG/MAG torch. The wire is loaded into the torch via the
wire purge pushbutton.
All manuals and user guides at all-guides.com
SMART 200 MP
MARK MARK MARK MARK DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION
1 Pressure reducing valve
2 Machine-gas connection
3 Earth clamp cable
4 MIG/MAG Torch
MARK MARK MARK MARK DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION
3 Earth clamp cable
4 MIG/MAG Torch
19