Base Settings; Base Setting Access; Tone Dialling Switch Over - Geemarc DECT250 Manuel D'utilisation

Base Setting

1 - Base setting access

Each time you want access to the base setting , you will have to enter PIN code
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you have changed it
Press OK
Now you are in the base menu
2 - Tone dialing switchover
Your DECT250 has been set to tone dialing at the factory , but if your network
requires pulse dialling, you will have to change the mode
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you have changed it
Press OK
Use and
Press OK
Use and to choice "Pulse"
Press OK
Press twice C or once
to select "Dial Mode"
to return to standby mode
22