Taurus 948700 Mode D'emploi page 4

securely connected.
3.2.1.5. Turn on the vacuum and start vacuuming.
3.2.1.6. When you have finished vacuuming, turn
the vacuum off and remove the plug from the mains
socket.
3.2. Use and care:
3.2.1. Vacuuming materials:
3.2.1.1. Ensure the micro particle filer is clean and
dry and installed on top of the dust bin assembly.
3.2.1.2. Ensure that the dust bin assembly is clicked
in its place.
3.2.1.3. Ensure that there are no blockages.
3.2.1.4. Ensure that the hose connections are
securely connected.
3.2.1.5. Turn on the vacuum and start vacuuming.
3.2.1.6. When you have finished vacuuming, turn
the vacuum off and remove the plug from the mains
socket.
3.3. Blockages:
3.3.1. In case of any blockages check the following
in this order:
3.3.1.1. Check the floor tool for any blockages.
3.3.1.2. Check the floor tool hose connector pipe.
3.3.1.3 Check the hose handle pipe.
3.3.1.4 Remove the dust bin and check the dust bin
inlet.
3.3.1.5 If there is still a blockage after following
these steps please contact the manufacturer or its
service agent or a similarly qualified person
3.4. Operating the vacuum:
3.4.1 Assembling your upright:
1. Remove the screw out of the handle as illustrated.
2. Insert the handle into the body, then remove the
dust cup assembly.
3. Tighten the screw into the body
4. Place the dust bin onto the machine and push
until it clicks into place.
5. Insert the handle hose end into the inlet pipe and
rotate the join clockwise. Then go to the other side
of the unit, open the cover and insert the handle into
the joint.