PRO-POINT 8857971 Manuel page 9

V1.0
1.1 When operating a tool outside, use an outdoor extension cord
marked W-A or W. These cords are rated for outdoor use and
reduce the risk of electric shock.
2. Do not operate this tool if the power cord is frayed or damaged as an
electric shock or surge may occur, resulting in personal injury or
property damage.
2.1 Inspect the tool's power cord for cracks, fraying or other faults
in the insulation or plug before each use.
2.2 Discontinue use if a power cord feels more than comfortably
warm while operating the tool.
2.3 Have the power cord replaced by a qualified service
technician.
3. Keep all connections dry and off the ground to reduce the risk of
electric shock. Do not touch plug with wet hands.
4. Prevent damage to the power cord by observing the following:
4.1 Do not pull on the cord to disconnect the plug from an outlet.
4.2 Keep cord away from heat, oil, sharp edges or moving parts.
4.3 Never use the cord to carry the tool.
4.4 Place the electrical cord in a position that prevents it from
coming into contact with the tool and from getting caught by
the workpiece. The cord should always stay behind the tool.
5. Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create a
protective trench.
6. Do not wrap cord around the tool as sharp edges may cut insulation or
cause cracks if wound too tight. Gently coil cord and either hang on a
hook or fasten with a device to keep cord together during storage.
LOW VOLTAGE
Low voltage may cause overheating due to higher power current being
drawn to the tool that will shorten the motor life.
An extension cord may cause a drop in power to the tool if it is too long
or the amperage rating is not correct. This may result in the following:
Visit www.princessauto.com for more information
Portable Metal-Cutting Band Saw 8857971
9