Publicité
Les langues disponibles
Les langues disponibles
8857971
3.
Grip the band saw by the auxiliary handle (C) and handle (G) before
starting the tool.
4.
Ensure that a minimum of two sawblade teeth will remain in the
material during the cut to keep the blade straight and prevent
kickback.
5.
Adjust the blade speed by turning the speed dial (E).
6.
Squeeze the trigger (F).
7.
Allow the band saw to reach full speed before starting the cut.
Maintain a firm grip on the tool with both hands to resist starting
torque.
8.
Tilt the unit so that the blade is vertical. To start a cut, use minimal
force to start a groove. Once the groove is started, allow the rest of
the blade to cut into the workpiece. Doing this will prevent the
blade from moving from side-to-side during cutting. The tool's own
weight provides the most efficient downward cutting pressure.
9.
Carefully avoid bringing the band saw blade suddenly and heavily into
contact with the upper surface of the workpiece. This will cause
serious damage to the band saw blade. To obtain maximum service
life of the band saw blade, ensure there is no sudden impact at the
beginning of the cutting operation.
10. Hold the saw firmly in both hands so that the saw does not fall against
the clamped or supported material when the cut is completed.
11. Release the trigger to stop the saw.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical replacement
parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
14
Portable Metal-Cutting Band Saw
For technical questions call 1-800-665-8685
V1.0
Publicité
