Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
4.2 System use
It is possible to select three different power levels according to sailing conditions, by pressing the
relevant push buttons. The indicator lights will show the enabled mode:
FISHING - low speed, good steering comfort and minimum power consumption
CRUISE - cruise speed, optimum steering comfort and low power consumption
MASTER DRIVE™ - best responsiveness with the minimum effort. It must be used during rapid
manoeuvres and mooring.
ATTENZIONE
If the steering wheel is not turned for 4 seconds while the Master Drive™ mode is enabled, the system
returns to the Cruise mode automatically. If the steering wheel is turned again, the system returns to
the Master Drive™mode.
This allows a reduced battery consumption ensuring a quick and effective system responsiveness
NOTICE: In Master Drive™ mode, the boater could feel light vibrations on the steering wheel.
NOTICE: The Master Drive™ position implies higher energy consumption.
If the red warning light (3) lights up, it indicates a
malfunction.
For further details, refer to the next paragraph.
NOTE FOR DUAL STATION SYSTEMS
WARNING
The
the two stations. Therefore, if two stations are installed, the actions on each station are added together
if they are carried out at the same time.
The controls on the panel work in parallel; if an action is carried out on one station, it is carried out on
the other station too at the same time.
4.3 Errors and signals
Possible malfunctions are signalled by the red warning light on the user interface.
MALFUNCTION
Power unit overtemperature
Low power voltage
General malfunction
page 44
of 143-
POWER ASSISTED STEERING SYSTEM
steering system is not equipped with a safety device which can disable one of
SIGNAL
Steady red light
Flashing red light
1 second on/1 second off
Installation, Maintenance and Owner's Manual
SOLUTION
Power unit overheating. The system goes to stand-
by mode. Wait until the power unit cools off (the
red light turns off) and try to restart the system.
NOTICE: due to great thermal inertia, the system
could restart even after a long time.
The system goes to stand-by mode. Contact the
Technical Assistance Service
3
Publicité
