Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
3.5 Installation of the power unit
- It is advisable to install the power unit far from heat sources, humid areas and fuel tanks in order to
ensure its longer duration in good working and efficiency conditions.
- The power unit should be installed in the battery compartment.
- Select a proper surface which can bear the weight of the product.
- In order to ensure a correct working in any sea condition and operation mode, the power unit must be
mounted vertically or horizontally.
- In case of floor mounting, put the power unit far from water puddles.
- Make sure electrical cables are not crushed.
WARNING
Never cut the cables; gather and store the exceeding part of them in a proper place.
WARNING
Do not extend the cables.
WARNING
Do not loosen or tamper with the fairleads and their connections.
1 After selecting a suitable place for the power unit installation (see the previous
note), turn the four silent block fixing plates (1) in the proper position, then
mount them on bracket (2). Put the other components according to the following
sequence: sealing washer (3), steel washer (4), self-locking nut (5) and
protective plug (6).
1
page 28
of 143-
POWER ASSISTED STEERING SYSTEM
NOTES FOR CORRECT INSTALLATION
2
Installation, Maintenance and Owner's Manual
3
4
5
6
Publicité
