Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
5 By using a 5 mm Allen wrench, fix the helm to the dashboard by means of screws (3) nuts (4) and
washers (5) after positioning flange (6) in the rear part of the dashboard and flange (7) with spacers
(8) in the front part of it (not supplied for 50cc helms).
Tighten the four self-locking nuts (4) by using a 10 mm wrench with a torque of 10 Nm (7,37 lb ft).
CAUTION
If the self-locking nuts (4) are disassembled, they must be replaced. (Contact our Technical Assistance
Service, see page 7).
6 Put seal (9) on the external part of the front
flange
page 24
of 143-
POWER ASSISTED STEERING SYSTEM
8
5
3
Installation, Maintenance and Owner's Manual
4
5
7
9
6
Publicité
