Publicité
Les langues disponibles
Les langues disponibles
English
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone, tablet, notebook etc.).
3. Connect the terminal device to the WLAN network (SSID)
EHEIM feeder XXXXXXXX.
4. Enter the network security key.
The network security key is found on the label between the feed drum and drive unit. Alternatively, you can also
scan the QR code 1 (see label) to establish the connection.
Calling up the website
5. Open your web browser and enter the following address: http://192.168.1.1
Alternatively, you can also scan the QR code 2 (see label) to open the software in the browser.
Initial configuration
6. Select the desired language from the language selection and follow the instructions for the initial configuration.
A comprehensive set of instructions for the software can be found on the main page via the QR code, or down-
loaded at www.eheim.com.
Meaning of the status LED
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: The automatic feeder is in master mode
‧ The status LED illuminates green: The automatic feeder is connected to another EHEIM digital device
Setting the feed quantity (⌦G/H)
1. Set the desired feed quantity using the slider
2. Start a manual feed to check the feed quantity. Place your finger on the touch field
the status LED
Place a white sheet of paper underneath to determine the feed quantity.
flashes.
on the drum unit.
25
for 1 – 2 seconds until
Publicité
