Tecno-gaz STERILAIR PRO Manuel De L'utilisateur page 40

Before setting the first program, you must Reset:
1. Make sure the sliding switch  is at RUN.
2. Press the key R ()with a pointed object.
The display will start to flash 0:00.
Setting time and day
1. Move the siding switch  to
2. Press the key 1...7 ( ) to enter the day of the week (1 = Monday, 7 = Sunday).
An arrow will appear on the display indicating the day of the week.
3. Use the keys h ( ) and m ( ) to set the time.
4. Move the switch  to RUN. The time of the day is activated.
Permanently ON, permanently OFF, AUTO
To set these functions, make sure the sliding switch  is at RUN.
Permanently ON: The device is permanently on.
The sliding switch  is at I. The symbol  appears on the Display.
Permanently OFF: The device is permanently off
The sliding switch  is at 0. The symbol  disappears from the Display.
AUTO: The device switches according to the set program. The sliding switch  is at
AUTO.
 ON mode: the symbol  appears.
 OFF mode: the symbol  does not appear.
Programming switching times
The switching in execution or selected will be indicated by a number at the bottom right
of the display with the relative symbol .
Advice for programming: every switch‐on point is closely linked to the subsequent
switch‐off point. They should always be programmed in pairs to prevent mistakes.
Attention: the shortest switching interval which can be set is 1 minute.
Procedure:
1. Move the sliding switch  to P .

On
13
ENGLISH
Off